Category Archives: PowerShell

PowerShell: Test-IsAdmin

Posted on July 19, 2015 by

Sometimes I only want a PowerShell function to run only if the user has local admin rights. This can be tested for by looking for the admin token. Here’s a function I use. I then call the function in my code using … Continue reading →

Posted in PowerShell | Tagged , , | Leave a comment

Managing DSC Resources in PowerShell Desired State Configuration (DSC)

Posted on April 16, 2015 by

PowerShell Desired State Configuration (DSC) Resources are an evolved type of function usually created by experienced PowerShell coders. Resources are at the very core of DSC and contain the code required to perform the actual configuration tasks in your deployments. My first post was … Continue reading →

Posted in Deployment, Desired State Configuration, DSC, PowerShell | Tagged , , , , | 3 Comments

PowerShell: Inside Desired State Configuration (DSC) – Get,Set and Test

Posted on April 15, 2015 by

Today, I’m going inside DSC to demonstrate DSC’s indempotance nature and also the Get, Set and Test functions. Continue reading →

Posted in Deployment, Desired State Configuration, DSC, PowerShell, Scripting | Tagged , | Leave a comment

PowerShell: Desired State Configuration – Getting started.

Posted on April 14, 2015 by

PowerShell DSC is really cool and the next big thing. This post will describe the feature in its most basic form and assume you’re new to the topic. Continue reading →

Posted in Desired State Configuration, PowerShell | Tagged , | 2 Comments

PowerShell: New-Password Function

Posted on April 12, 2015 by

OK, so I’ve been off the grid for a while now. But that doesn’t mean I’ve not been busy. Quite the opposite in fact. I’ve taken a year out from work on paternity with my baby Son. During this time, … Continue reading →

Posted in PowerShell | Tagged , , | 10 Comments

SCCM PowerShell: Connect to SCCM Function

Posted on September 9, 2014 by

    Today’s post is another time-saver function I wrote to connect to SCCM. Again, it is designed to eliminate the need to hard code the module path and/or the SCCM primary site. It allows me to just type Connect-SCCM to import the module … Continue reading →

Posted in MDT 2010, MDT 2012, MDT 2013, PowerShell | Tagged , , | 2 Comments

MDT PowerShell: Connect to MDT Function

Posted on September 8, 2014 by

  Todays post is a time-saver function I wrote to connect to MDT shares. It allows me to just type Connect-MDT to import the module then enter to the MDT PSdrive. It discovers the location of the MDT module(from the registry) and uses the Restore-MDTPersistentDrive … Continue reading →

Posted in MDT 2010, MDT 2012, MDT 2013, PowerShell | Tagged , , | 5 Comments